Tamiya German Flakpanzer Gepard - # 49510 (Radio Controlled Model Review)

  Released by Tamiya circa 1993, the German Flakpanzer Gepard (#49510) came as a Full Kit.

  Based on the hull of the Leopard 1 tank, with a large fully rotating turret, the Flugabwehrkanonenpanzer Gepard ("anti-aircraft cannon tank Cheetah") better known as the Flakpanzer Gepard, is an all-weather capable German self-propelled anti-aircraft gun (SPAAG). Developed in the 1960s and fielded in the 1970s and has been upgraded several times with the latest electronics. It constituted a cornerstone of the air defence of the German Army and a number of other NATO countries until the Gepard was phased out in late 2010, to be replaced by "SysFla".

  This model comes with metal bushings, that after a short while, when dust and grit get into them, can actually wear into the metal drive shafts that spin in them - we recommend these should be replaced by a full set of steel shielded ball bearings ASAP.

Tamiya Manual.

Rating: 4 RCScrapyard

Electric Motors for RC Models

Q/  What does 15x2 or 17x3 mean?
A/  The first number relates to the number of times the wires are wound round each of the 3 armature segments, the second number relates to the number of wires side by side. So a 15x2 would have 2 wires laid side by side and wrapped around each segment 15 times.

Q/  What is the difference in performance between a Low Turn motor (eg 11x1) and a High Turn motor (eg 27x1)?
A/  A Motor with Less Turns like an 11x1 means high current draw from the batteries which corresponds to less runtime, but More Power (Torque or Punch) Best for tracks with lots of corners and short straights where fast acceleration is needed. (use a small pinion)
Motors with More Turns like a 27x1 give you More runtime, but Less Power. So you get a smoother response and are therefore easier to drive. Better for less experienced drivers and Long straight, sweeping corner tracks. (with a large pinion). This is correct for Brushed, Modified and Stock Motors as well as Brushless Motors.

Q/  How do the number of winds effect a motor?

Efficient Soldering

   In the sport of Radio Controlled racing, there are a number of things you have to learn to get you up there with the best. One of the most difficult, for those with little practical skill, is the art of Soldering.

   For their 540 silver can motors, Tamiya provide two wires, typically green and yellow, soldered to the endbell, with two bullet connectors to plug into the speed controller. While this is fine for bashing around the back yard, as you advance to a higher level you will soon find just how inefficient this method is.

   Motor wires are best soldered directly to the ESC. That way no energy is lost through high current draw. Some of the top drivers at one time even used to solder their batteries directly to the ESC.