Tamiya King Tiger (Production Turret) - 56004 (Radio Controlled Model Review)

  Released by Tamiya on July 17, 1981, the German King Tiger (Production Turret) (#56004) (Panzerkampfwagen VI "Tiger II" (Sdkfz182) Ausf-B ) is now considered a rare collectors model.

  A front-mounted gearbox, has a single electric motor for forward/reverse left/right turns and another servo operated gearbox provides 360 deg turret rotation. Metal torsion bars and suspension arms combine with the wide tracks to smoothly absorb bumps and dips in the terrain.

  The German King Tiger tank first appeared towards the end of the 2nd World War in 1944. The heavy armored design has 150 mm front plates and 80 mm side plates, with 700 horsepower Maybach HL 230 - P 30 engine. The first 50 prototypes came with a turret designed by Porsche, but the mass production type came equipped with an improved turret designed by Henschel and a powerful gun which can penetrate 150 mm thick armor plate at 2000 m. Approximately 440 King Tiger tanks were produced from the summer of 1944 to March 1945. The German army intensively used it in the battle of the Ardennes in December 1944 and it was a major threat to the advancing Allied Army towards the end of the war.

  This model comes with metal bushings, that after a short while, when dust and grit get into them, can actually wear into the metal drive shafts that spin in them - we recommend these should be replaced by a full set of steel shielded ball bearings ASAP.

Rating: 4 RCScrapyard

How to put on Decals

   After spending lots of time and effort to paint your bodyshell, you come to the point where you make it look good by putting on all those flashy decals, but before you rush in with the scissors and start cutting, there are a few things you should do first.

   Good preparation is key to a perfect job, so before you do anything with your decals, you must first of all wash your hands, and then make sure the bodyshell is clean and no oil or grime from your previously grubby fingers remains on the Polycarbonate Lexan surface. Methylated spirits is the thing to use, or failing that, use one of those wipes you use for your computer monitor screen.

   As the body shell dries, you can carefully cut out the decals from the sheet. Do the big ones first and leave the smallest ones for last.

Bearing Seals

   If you were to ask anyone with a modicum of experience in RC, they will tell you that the best modification you can make to a basic RC model, is to add a set of ball bearings.

   Quite a few of the entrance level models at the time this article was written, come with plastic and sintered brass ring type bearings. If these bearings are installed in the model and coated with grease as advised in the car manual, dust and grit can be caught in that grease and be dragged into the bearing where it can abrade the shaft that spins in it and it won't be long before it becomes a very sloppy fit, causing all kinds of problems.

   But what should you look for when buying bearings? There are a number of types of seal used on ball bearings, and there is much debate concerning which is the best for RC.